Smoother behaviour Release knob

[M-Prod]

The release parameter jumps from ms to seconds above 1s. I know the reason behind this because the higher you go, the less you notice the increase. However in my opinion this really feels like a sudden change in how the parameter responds to the knob that feels unnatural around 900ms-2s.
Could this be made more gradual? Maybe logarithmic instead of two separate speeds below and above 1ms.

[John Bowen]

We’ve talked about this, but I can ask Jim again as to what might be done. It’s really not too bad if you are turning the knob a bit slower, but I understand your point.